controlcode.h File Reference

#include <inttypes.h>

Go to the source code of this file.

Namespaces
	Hantek

Enumerations
enum	Hantek::ControlCode : uint8_t {   Hantek::ControlCode::CONTROL_VALUE = 0xa2, Hantek::ControlCode::CONTROL_GETSPEED = 0xb2, Hantek::ControlCode::CONTROL_BEGINCOMMAND = 0xb3, Hantek::ControlCode::CONTROL_SETOFFSET = 0xb4,   Hantek::ControlCode::CONTROL_SETRELAYS = 0xb5, Hantek::ControlCode::CONTROL_SETVOLTDIV_CH1 = 0xe0, Hantek::ControlCode::CONTROL_SETVOLTDIV_CH2 = 0xe1, Hantek::ControlCode::CONTROL_SETTIMEDIV = 0xe2,   Hantek::ControlCode::CONTROL_ACQUIIRE_HARD_DATA = 0xe3, Hantek::ControlCode::CONTROL_SETNUMCHANNELS = 0xe4, Hantek::ControlCode::CONTROL_SETCOUPLING = 0xe5, Hantek::ControlCode::CONTROL_SETCALFREQ = 0xe6 }
	All supported control commands. More...